Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has been offering you issues, so you require to fix it. You can repair it by changing a motherboard, a photo-eye sensing unit, the primary drive equipment, or the set-limit buttons. You can also examine if the safety sensing units are working appropriately.

Replacing a circuit board

Replacing a circuit card for your garage door opener calls for a couple of actions as well as devices. Initially, you require to shut off the circuit breaker and separate any wires. Next off, open up the motherboard cover. This will certainly aid you to diagnose the issue as well as figure out if you require a new board. Next off, remove the old board and its wire connectors.

You can then proceed to change the circuit board. The substitute procedure is easy and takes about 10 mins. A new circuit board will certainly set you back regarding $80. To protect your brand-new circuit board from power surges, you can buy a rise protector.

Replacing a photo-eye sensing unit

Changing a photo-eye sensor can be a fairly simple job. First, eliminate the sensor from the door and also make sure it is positioned appropriately. If the sensor is angled by any means, it may not be obtaining the correct signal, which could be causing the strobe lights. If you notice that the photo-eyes are out of placement, you might need to have a professional come and also deal with the trouble.

The photo-eye sensing unit consists of 2 items that mount on the outside of the door tracks as well as toward the floor. The picture eyes will have a little LED light and ought to be solid in shade. If the light is blinking, its likely the photo-eye is defective and also will certainly require to be replaced.

Changing a major drive equipment

To change a garage door opener main drive equipment, beginning by removing the cap from the chain pulley-block. Next off, remove both screws holding the drive equipment to the sprocket assembly. Now, you can unfasten the 3 tension pins. Squeeze them from both sides and after that eliminate them. Then, disconnect the 3 wires from the garage door opener electric motor. These cables must be white, red, and blue.

As soon as you have actually removed the old equipment, mount a brand-new one. Make sure to oil it well. Place the new equipment into the shaft, making sure to align the placing holes. Make sure the gear and also gear assembly are located properly to guarantee smooth operation. Next, use a hammer as well as a nail to drive a pin right into the new gear.

Changing the set-limit buttons

The very first thing you ought to do if your garage door is not functioning appropriately is to inspect the set-limit switches. You might need to readjust them to ensure that the door shuts earlier or stops before it gets to the flooring. You can check this by checking out your garage doors guidebook or online.

To change the set-limit buttons, youll need a screwdriver or socket. Adjust the handle clockwise or counterclockwise until the door moves up and stops, or decreases its range. To check for proper traveling range, gauge the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top